Bottom Bracket Conversion

          A common problem that arises nowadays, with the influx of new bottom bracket standards is what, why and how to move from one system to another. With the threaded bottom brackets of old there was not many issues with a change to the newer outboard bearing systems but, with the move to frame specific systems, the switch is no longer as simple or, in some cases even possible.
          One of the most common issues is the press fit systems more specifically the PF30 and BB30 standard. Whilst both these systems are good and make for a solid crank interface often the issue arises because the frame has been purchased as an upgrade for a specific build kit already owned and the owner needs to convert the bottom bracket over to a threaded external system. There have always been a couple of options for this however, the good folk at Praxis Works, makers of our favorite chain-rings, have come up with a superb new conversion kit for the purpose.
         One of the biggest problems with conversions and even the press fit systems as a whole is that they tend to creak and groan. This is because the adaptors are, like the bearings, seperate from each other. With the Praxis system the cups are actually conected to each other by means of a threaded sleeve. This sleeve is very tightly machined but also as it is installed it flares out and takes care of any wiggle that may cause problems.
          If you are thinking of doing a conversion or have already performed a conversion with another product take a look at the Praxis system. It is the only way I will go in future. If you want more information or need a kit just let us know as we are Praxis dealers and use the full range of their products.

www.praxiscycles.com

Posted on November 14, 2012 .